Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
US
CA
Figure 10
close-up of control
Starting your refrigerator
Plug the refrigerator power cord into a wall outlet. Your
refrigerator will begin cooling after power is applied.
If your refrigerator does not start, check that the refrigerator
is turned on and the set temperature is cold enough.
Turning your refrigerator ON or OFF
If the refrigerator is on, the refrigerator temperature will be
shown on the display. To turn the refrigerator off, press and
hold the "ON/OFF" button for three seconds. "OFF" will ap-
pear on the display.
If the refrigerator is not on, "OFF" will be shown on the
display. To turn the refrigerator on, press and hold the "ON/
OFF" button for three seconds. The refrigerator tempera-
ture will be shown on the display.
Set temperature
To set the refrigerator temperature, press and hold the
"SET" button. When the "SET" button is pressed, the
display will show the set temperature. While holding the
"SET" button, press the "WARMER" or "COLDER" buttons
to adjust set temperature.
Refrigerator operation
The available temperature range of the refrigerator is 34° to
42°F (1° to 6°C).
It may take up to 24 hours for your refrigerator to reach
desired temperature. This will depend on amount of content
loaded and number of door openings and closings.
For best results allow refrigerator to "pull down" to desired
set temperature before loading. Once contents are loaded,
allow at least 48 hours for temperature to stabilize before
making any adjustments to the set temperature.
Alarms
Your digital display function will monitor refrigerator function
and alert you with a series of audible and visual alarms.
• Door Ajar Alarm: If the door has been left
open for over five minutes, the alarm will
sound in one second intervals. The display
panel will flash "do" and the Alarm LED located at the top
left of the display below the word "Alarm" will be illuminat-
ed. This will stop as soon as the door is closed.
USING YOUR ELECTRONIC CONTROL
Alarm
F
Set
Colder
Warmer
Press and Hold
Press and Hold
ON/OFF
• Temperature Sensor Fault: If the control-
ler detects that the temperature sensor is not
properly functioning, a temperature sensor
alarm will sound in one (1) second intervals. "E1" will flash
on the display panel and the Alarm LED located at the top
left of the display below the word "Alarm" will be illuminated.
• High and Low Temperature Alarm: If your
unit reaches an unacceptable temperature
outside of your set-point, the alarm will sound
in (1) second intervals. The display panel will
flash either "Hi" or "Lo" depending upon the
condition and the Alarm LED light at the top
left of the display below the word "Alarm" will be illuminat-
ed. These alarms indicate that the compartment tempera-
ture has moved 10° or more from the set point for more
than 1 hour duration. The alarm will remain active until the
condition is corrected.
During initial appliance start-up, the high temperature alarm
may sound until the interior temperature reaches set point.
The high temperature alarm can also occur if the door re-
mains open during an extended period of time (i.e. cleaning
or door ajar alarm condition), high usage or loading with
warm product. After a high temperature alarm condition check
all perishables to ensure they are safe for consumption.
Alarm Mute
Press any key to mute the audible portion of an alarm.
This action will only mute the alarm. If the condition that
caused the alarm continues, the alarm code will continue to
flash and will sound for 20 seconds every 60 minutes.
10
Figure 11
NOTE
NOTE
Publicité
Chapitres
Table des Matières
Dépannage
