Before You Start Using Your Ice & Water Refrigerator - Fisher & Paykel Ice & Water E522B Guide D'utilisation

Before you start using your Ice & Water refrigerator
Check refrigerator is switched on and has cooled for at least 2 hours before use (refer to page 19
■ ■
– The temperature of your refrigerator and freezer).
Check that the water filter has been connected and turned on.
■ ■
Turn on the ice maker (refer to page 24).
■ ■
At first use allow approximately a minute from when the dispensing pad is pushed until water is
■ ■
dispensed. This will allow the tank to fill.
Run through and discard the first 3 qt (3 L) of water from the dispenser, stopping intermittently
■ ■
(refer to page 21 – First use). Failure to do this will result in excessive dripping from your dispenser.
Discard the first 3 harvests of ice (8 cubes are produced per harvest), refer to page 24 – First use.
■ ■
You are now ready to enjoy ice and water from your Active Smart™ refrigerator.
Please note that once installation is complete a few drips may appear out of the dispenser over
the next few days as the remaining trapped air is cleared.
Fig.15 Water dispenser
US
15
CA