Yamaha TSX-130 Mode D'emploi page 7

■ Before using the remote control
■ Using the remote control
■ Replacing the battery in the remote control
Change the battery when the operation range of the remote control decreases.
Use a straight pin to remove
the cover.
Notes
• Insert the battery according to the polarity markings (+ and –).
• If the batteries run out, immediately remove them from the remote control to prevent an explosion or acid leak.
• If a battery starts leaking, dispose of it immediately. Be careful not to let the leaking battery acid touch your skin or clothing.
• Before inserting new batteries, wipe the compartment clean.
• Dispose of batteries according to your regional regulations.
1 Remove the battery insulation sheet before using the remote
control.
2 Remove the transparent sheet before using the remote control.
Use the remote control within 6 m (20') of this unit and point it
toward the remote control sensor.
Notes
• Do not spill liquid on the remote control.
Within 6 m
• Do not drop the remote control.
(20')
• Do not leave the remote control in the following places:
– hot or humid places such as a bathroom or near a heater
– extremely cold places
– dusty places
Replace the battery with
a new CR2025 battery.
PREPARATIONS BEFORE USING THIS UNIT
Close the cover.
3
En