Schneider SCB 250 V2 B Mode D'emploi page 22

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1. This appliance is equipped with the environmental-friendly refrigerant R600a.
The refrigerant R600a is inflammable. The components of the cooling
circuit must neither be damaged during transport nor use.
2. If any part of the cooling circuit is damaged, the appliance must not stand
near a fire, naked light or spark-generating devices. Contact the shop you
purchased the appliance at immediately.
3. If gas is set free at the installation site:
a) Open all windows.
b) Do not unplug the appliance and do not use the control panel or
thermostat.
c) Do not touch the appliance until all the gas has gone.
d) Otherwise sparks can be generated which will ignite the gas.
4. Keep all components of the appliance away from fire and other sources of
ignition when you dispose of or decommission the appliance.
5. Do not install the appliance near of volatile or combustible materials (e.g. gas,
fuel, alcohol, paints) and in rooms which may have poor air circulation (e.g.
garage).
6. EXPLOSION HAZARD! Do not store any explosive materials or sprays,
which contain flammable propellants, in your appliance. Explosive mixtures can
explode there.
7. While unpacking, the packaging materials (polythene bags, polystyrene pieces,
etc.) should be kept away from children. CHOKING HAZARD.
8. Do not connect the appliance to the electric supply unless all packaging and
transit protectors have been removed.
9. Operate the appliance with 220~240V/50Hz/AC only. All connections and
energy-leading components must be replaced by an authorized professional.
10. Do not use a socket board or a multi socket when connecting the appliance to
the mains.
11. A dedicated and properly grounded socket meeting the data of the plug is
required to minimize any kind of hazard. The appliance must be grounded
properly.
12. Check that the power cord is not placed under the appliance or damaged when
moving the appliance.
13. The technical data of your energy supplier must meet the data on the model
plate of the appliance.
14. Your domestic circuit must be equipped with an automatic circuit breaker.
15. Do not modify the appliance.
16. Turn off the power before you install the appliance and before you connect it to
the mains. RISK OF FATAL ELECTRIC SHOCK!
17. Disconnect the appliance from the mains before you clean or maintain it.
18. Do not use any electric appliances inside the food storage compartments of
your appliance unless they are recommended by the manufacturer of your
refrigerator.
19. Do not put any heat-radiating appliances onto your appliance.
22

Publicité

Table des Matières
loading

Table des Matières