INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
2)
Checking the threads of the castellated nut and of the tie-rod:
Remove the nut cover (1), split-pin (2) and the castellated nut (3). Check the
condition of the threads of the nut (3) and of the tie-rod (25). In case there are
any signs of play or seizure the parts must be replaced immediately;
3)
Wear check:
Check that the wear of the coupling pin (14) (see chapter 5.2 REPLACEMENT OF
THE MECHANISM UNIT AND THE COUPLING PIN, page 22/32) and of the upper
bush (6) and of the lower bush (10b) (see chapter 5.6 REPLACEMENT OF THE
UPPER AND LOWER BUSHES, page 26/32) are within the recommended limits
shown in the figure;
N
The wear data below is specified according to the technical
O
T
specification ISO TS 20825
E
25
DRAWBAR COUPLING E 40
25M 25P
10b
14
10b
"S"
"S"
Ø 31,2 max.
PAG.
19/32
CHAP . 4
REV. 00
Ø 39,9 max.
6
14
Ø 36.5 min.
Ø 36.5 min.
Ø 29 min.