Fisher & Paykel RF175W Instructions D'installation Et Guide D'utilisation page 35

Cleaning and caring for your refrigerator
Humidity Control System
Important!
When cleaning the shelf above the vegetable bins,
we recommend that you do not disassemble the
Humidity Control System from the shelf.
If cleaning is necessary, follow these instructions:
Remove the shelf by slightly tilting up the front
1
and lifting the rear of the shelf at the same time.
Then pull the shelf straight out.
Unclip the lid from the clips at the back of the
2
shelf and gently lift out from under the side
retainers (refer to Fig.25).
Important!
Do not to pull the lid out of the retainer on the
front of the shelf.
Hold the lid up vertically (refer to Fig.26) and
3
clean the underside of the shelf and lid.
Once you have finished cleaning the shelf and
4
lid, position lid back in place by fitting the lid
under the side retainers (refer to Fig.27).
Fasten lid to rear clips. Ensure that the cover
5
is fully secure at the front and the back of the
shelf (refer to Fig.28).
To install the shelf back into the refrigerator, tilt the
6
front edge up and rest the shelf on the rear lugs on
the side walls of the refrigerator. Then gently rest
the shelf on the front lugs. Ensure shelf is secure
before letting go of the shelf.
Retainer
Humidity Slides
Fig.25 Removing lid from
rear clips and side retainers
Fig.26 Hold the lid vertically for cleaning
Fig.27 Fit lid under side retainers
Fig.28 Fasten lid to rear clips
and ensure lid is secure
EN
33