6. Leveling the refrigerator door (RF195A only)
If doors are uneven, do the following:
6
Determine which door needs to be raised.
a
Turn the front roller adjustment screw (
b
side clockwise to raise front corner of door.
If one adjustment screw has reached the limit of its
c
adjustment range and the doors are still not level, lower
the opposite door by turning the roller adjustment screw
counterclockwise.
Check with level to verify ⁄" (10 mm) tilt to the back for
d
proper door closure.
Once refrigerator is aligned, screw feet firmly in place and
e
attach toe grille (refer to step 5d).
7. What to do if the product is unstable (all models)
Gently pull the refrigerator forward and screw down the feet
7
until they make contact with the floor.
Push the refrigerator back until the rear rollers contact the
8
floor.
Measure the gap under the front foot, which has come
a
off the floor.
Obtain some solid packing material (hardwood, plastic,
b
etc), which fits firmly into the gap under the foot.
Note: do not use metallic materials that may corrode, stain
and/or damage floor coverings.
Installation instructions
Fig.3 ) on that
a,
Fig.5 Uneven door alignment
Example only
Un-level floor
This foot lifts off the floor when
top front is gently pushed back
Fig.6 Unstable refrigerator
EN
11