Fisher & Paykel DCS 30 BGC Instructions D'installation Et Guide D'utilisation page 17

INSTALLATION
CART ASSEMBLY INSTRUCTIONS
STEP 5
Side tray adjustment
1. Take the tray and place it onto the handle at a upright position. Make sure the tray sits snugly around the handle.
2. Then tighten the rest of the loose bolts that were not tightened in Step 1.
Side shelf adjustment
1. With extended use, the shelves may become
unleveled and need to be readjusted.
2. In between the bracket where the handle
slides in is a 5/8" long adjustment screw.
Grasping the handle as shown, raise up the
shelf and hold while with other hand using a
3/32 allen wrench turn to the desired level.
FIG. 17
3. Slide drip tray/pan back into place.
4. Move side shelf bars up and set trays into place.
STEP 6
Gas Hookup - LP
Attach LP gas line connector hose assem-
bly (as shown in "LP Gas Hookup" section)
and then connect to LP tank as shown
below.
Shelf Level
Adjustment
FIG. 15
FIG. 18
FIG. 20
15
FIG. 16
FIG. 19
FIG. 21