Fisher & Paykel DCS 30 BGC Instructions D'installation Et Guide D'utilisation page 16

INSTALLATION
CART ASSEMBLY INSTRUCTIONS
FIG. 10 Lift grill over rear flange of cart (be
aware of pinch points).
STEP 3
Front End Screw Installation
1. Install remaining (3) screws (10-24X1/2") in front of head to cart.
2. Slide drip tray/pan back into place. Move side shelf bars up and set
trays into place.
STEP 4
Bolt Installation
After head is in place, install the bolt (1/4-20 x 2") omitted from Step
1, and tighten all bolts on bracket. Tighten until sides are flush with
the trim only.
Note:
This bolt secures side bracket to grill head assembly for added side shelf
strength. Apply Loctite 242 (blue) to the first 3-4 threads prior to instal-
lation of this bolt
Pinch Point
FIG. 11 Grill head should rest over rear cart
flange as shown above.
14
FIG. 12 Secure grill to rear of cart with (2) phil-
lips-head screws provided (10-24 x 1/2").
FIG. 13 Secure grill to the front of the cart with Phillips-
head screws (provided).
FIG. 14 Front right side