Intended Use; Product Contents - VOLTCRAFT LCR-100 Mode D'emploi

3. Intended use

• Measuring and displaying the electric parameters of spools (L), capacitors (C) and resistors (R)
• Measuring of inductance up to 20 H
• Capacity measuring up to 110 µF
• Measuring resistance values of up to 110 MOhm.
• Continuity check (< 30 ohms acoustic) and diode test.
The measuring functions and ranges are selected via the rotary switch. The automatic measuring range selection is
active in the resistance and capacity measuring range.
Modules may only be connected to the measuring device when the power is off and the device was discharged. No
voltage may be applied to the measuring device. The potential difference between the measuring instrument connec-
tion points and ground must never exceed 36 V DC/AC.
The measuring instrument must not be operated when it is open, i.e. with an open battery compartment or when the
battery compartment cover is missing. Measurements must not be carried out under unfavourable ambient conditions.
Unfavourable ambient conditions are:
• Dust and flammable gases, vapours or solvent,
• Thunderstorms or similar conditions such as strong electrostatic fields etc.
For safety reasons, when measuring only use measuring cables or accessories which are adjusted to the specifica-
tions of the multimeter.
Any use other than the one described above damages the product. Moreover, this involves dangers such as e.g. short
circuit, fire, electric shock, etc. No part of the product must be modified or rebuilt!
Read the operating instructions carefully and retain them for later reference.
Observe the safety instructions under all circumstances!

4. Product contents

• LCR meter with block battery 9 V
• Measuring lines with hook catches red and black
• Bag
• Operating instructions
Up-to-date operating instructions
Download the latest operating instructions via the link www.conrad.com/downloads or scan the QR code. Follow the
instructions on the website.
21