Initial Setup With Auto Start-Up Wizard - Onkyo TX-8270 Mode D'emploi

> Before Start > Part Names

Initial Setup with Auto Start-up Wizard

Initial Setup
1
INPUT
2
> Install
3
> Initial Setup > Playback
Advanced Setup | Supplementary Information | Others
Initial Setup starts automatically
When you turn the unit on for the first time after purchasing
it, Initial Setup is automatically shown on the TV to enable
you to make settings required for startup using simple
operations following onscreen guidance.
1. Switch the input on the TV to that assigned to the unit.
2. Put batteries into the remote controller of this unit.
3. Press Í on the remote controller to turn the unit on.
4. Select the item with the cursors of the remote controller
and press ENTER (a) to confirm your selection. To return
to the previous screen, press RETURN (b).
a
0 If you terminate the procedure on the way or want to
change a setting made during Initial Setup, press SETUP
on the remote controller, and select "7. Miscellaneous" -
"Initial Setup" and press ENTER. To select the language
displayed again, change "OSD Language" (P35).
∫ 1. Source Connection
Check that each input source is connected correctly. Follow
the guidance, select the input you want to confirm, start
play of the selected player, and confirm that the images
appear on the TV and that sound is played.
∫ 2. Network Connection
Set up Wi-Fi connection with an access point such as a
wireless LAN router. There are the following two methods of
b
17
En