Sony Handycam HDR-TD10 Mode D'emploi page 15

4
When the battery is charged, disconnect the AC Adaptor from the DC IN
jack of your camcorder.
Charging time
Approximate time (min.) required when you fully charge a fully discharged battery pack.
Battery pack
NP-FV50
NP-FV70 (supplied)
NP-FV100
The charging times shown in the table above are measured when charging the camcorder at a

temperature of 25 C (77 °F). It is recommended that you charge the battery in a temperature range of 10

C to 30 C (50 °F to 86 °F).
 
Tips

See page 61 on recording and playing time.

When your camcorder is on, you can check the approximate amount of remaining battery power with the

remaining battery indicator at the upper right on the LCD screen.
To remove the battery pack
Close the LCD screen. Slide the BATT (battery) release lever () and remove the battery
pack ().
To use a wall outlet (wall socket) as a power source
Make the same connections as "Step 1: Charging the battery pack" (p. 14). Even if the battery
pack is attached, the battery pack is not discharged.
Charging time
155
195
390
US
1