Other Connections; Connecting Auxiliary Components; Connecting An Analog Audio Component; Listening To An External Audio Source - Pioneer HTS-GS1 Mode D'emploi

Other connections

Chapter 8
Other connections
Important
• When connecting this system or changing
connections, be sure to switch power off and
disconnect the power cord from the wall socket.
After completing all connections, connect the power
cord to the wall socket.

Connecting auxiliary components

The receiver subwoofer has optical and coaxial digital
inputs for digital playback components, such as DVD, CD
and MD players.
CONTROL IN
MCACC
SETUP MIC
CONTROL SPEAKERS
SYSTEM CONNECTOR
OUT SUB WOOFER R SURROUND L
USE ONLY WITH DISPLAY UNIT.
R L
CENTER FRONT
AC IN
DVD player, etc.
• Connect the digital output jack on your DVD
player, etc. to one of the DIGITAL input jacks on the
receiver subwoofer.
Use a commercially available coaxial or optical cable to
make this connection.

Connecting an analog audio component

You can use the ANALOG input jacks to connect an
analog audio component, such as a tape player. See
Using this system for TV audio on page 13 for connection
details (this explains connecting the audio output from
your TV, but any analog audio component can be
connected).
ANTENNA
FM AM
UNBAL 75Ω LOOP ANTENNA
AUDIO INPUT
DIGITAL
DVD/DVR XBOX 360 DIGITAL ANALOG
(COAXIAL) (OPTICAL) (OPTICAL)
L
R
DIGITAL OUT
or
(COAXIAL)
DIGITAL OUT
(OPTICAL)

Listening to an external audio source

You can connect both analog and digital external audio
sources to this system. Digital audio sources include
digital satellite receivers, CD recorders, etc. Analog
sources include your TV. See also Using this system for
TV audio on page 13 and Connecting auxiliary
components above.
AUDIO INPUT
XBOX 360 DVD/DVR
SET UP /TUNE
1 2
1 If the system isn't already on, press
switch on.
Also make sure that the external source (TV, satellite
receiver, etc.) is switched on.
2 Select DVD/DVR, DIGITAL or ANALOG to select the
source for playback.
These buttons correspond with the input jacks on the
receiver subwoofer.
3 If necessary, start playback of the external source.

Connecting external antennas

For an external AM antenna, use 15 ft. to 18 ft. (5 m to 6
m) of vinyl-insulated wire and set up either indoors or
outdoors. Leave the loop antenna connected.
Outdoor antenna
Indoor
antenna
(vinyl-coated
15 ft. to 18 ft.
wire)
(5 m to 6 m)
For an external FM antenna, Use a PAL connector to hook
up an external FM antenna.
DIGITAL ANALOG
+ +
SR
3
RECEIVER to
AM
LOOP ANTENNA
PAL connector
08
27
En