Safety Instructions - LEM SATURN 100 plus Manuel D'utilisation

Safety Instructions

Safety Instructions
This measuring equipment must not be used or utilized except by qualified
staff and in accord with its technical data in compliance with the safety
precautions and instructions set forth below. In addition, use of this
equipment requires compliance with the legal and safety instructions
pertaining to the specific application in question. Similar precautions apply to
the use of accessories.
When connecting this measuring instrument to electricity distribution supply
networks and test objects dangerous contact voltages may be present on the
connecting parts or occur during measurement. Therefore, pay particular
attention to all warnings indicated in the operating manual or displayed by the
instrument.
Fault-free and reliable operation of this instrument requires suitable transport and
storage, setting-up and assembly, as well as care in operation and maintenance.
If there is reason to believe that risk-free operation is no longer possible, the instrument
should be switched off immediately and protected against accidental restarting. Risk-
free operation shall be deemed to be no longer possible if and when the instrument
shows visual damage,
fails to work in spite of functioning batteries,
has been exposed for some time to unfavorable conditions (e.g. storage beyond the
permissible climatic limits without adaptation to the ambient climate, dewing etc.),
has been exposed to major strain during transport (e.g. been dropped from some
height without visible external damage etc.), or
shows „– E –" on the display (see chapter 3.11 "Display symbols").
WARNING: No measurements must be performed unless measuring
circuits are protected by fuses.
When connecting to a supply network the overload capacity of the
instrument must be observed (600V AC max.).
For safety reasons, only those accessories listed with the order codes
may be used.
2