Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
When an error message is displayed
during measurement
If an error is detected during measurement, the
measurement is canceled and "Error" appears on the GUI
screen. Check the error and solve the problem. For details
on each error message, see page 70.
Press jCursor n once, press jCursor l / h
to select "Retry" or "Exit" and then press
jENTER.
E-1 : No Front Speakers
FrontL/R channel signals are not detected.
Check wiring and connections of the front L/R speakers.
Retry
Retry
Performs "Auto Setup" again.
Exit
Terminates the measurement and "Auto Setup".
y
• When "E-5:NOISY" appears, you can continue measurement. To
continue measurement, select "Proceed". However, we recommend that
you solve the problem first and then perform measurement again.
When a warning message is displayed
after measurement
If a problem occurs during measurement, "Check xx
warning(s)" appears on the GUI screen. Check the
warning and solve the problem. For details on each
warning message, see page 71.
Auto Setup
Speaker Config :
Distance (Min / Max) :
Level (Min / Max) :
Check 2 warnings
Set
y
• Optimization will not be performed while a warning message is
displayed. We recommend that you solve the problem and perform "Auto
Setup" again.
1
Press jCursor n / k to select "Check xx
warning(s)" and then press jENTER.
Details of the warning message are displayed. If there
are multiple warning messages, you can display the
next message using jCursor h.
2
To return to the top result display, press
jENTER again.
Error
Exit
Move focus
Result
3 /4 / 0.1
8.0ft / 8.5ft
-3.5dB / +4.5dB
Cancel
See details
Select items
Optimizing the speaker setting for your listening room (YPAO)
23
En
Publicité
Table des Matières
