Bosch PKP 18 E Instructions D'emploi page 6

Product Specifications
Glue Gun
Order number
Rated power
Heating
Maintaining heat
Heating time
Glue temperature
Gluing capacity
Glue stick dia.
Weight approx.
Protection class
Please observe the order number of your unit. The
trade names of the individual units may vary.
Product Elements
1 Nozzle
2 Glue stick
3 Feed trigger
4 Support stand
5 Heat protection cover
Not all the accessories illustrated or described are in-
cluded in standard delivery.
Intended Use
The glue gun is intended for the quick gluing of clean,
dry and grease-free materials with glue heated to its
melting point.
For Your Safety
Working safely with this unit is pos-
sible only when the operating and
safety information are read com-
pletely and the instructions con-
tained therein are strictly followed.
If the cable is damaged or cut through while work-
s
ing, do not touch the cable but immediately pull the
mains plug. Never use the unit with a damaged
cable.
Before each use of the unit, check the cable and
s
plug. If damage is detected, do not use the unit.
Have repairs performed only by a qualified techni-
cian. Never open the unit yourself.
1 609 929 460 • (02.03) T
PKP 18 E
0 603 264 5..
[W] 200
[W] 16
[min] 7
[°C] 200
[g/min] 20
[mm] 11
[kg] 0.35
/ II
English–1
The unit must not be damp and must also not be
s
operated in damp surroundings.
Connect units that are used outdoors by means of
s
a fault current protection switch (FI) with a maxi-
mum triggering current of 30 mA. Use only an ex-
tension cable that is approved for outdoor use.
Always direct the cable to the rear away from the
s
unit.
For pauses in the work of more than 30 minutes,
s
pull the mains plug.
Children may only use the unit under the supervi-
s
sion of adults.
Bosch is able to ensure flawless functioning of the
s
unit only if the original accessories intended for it
are used.
Before Use
Screw the nozzle 1 onto the gun. Insert the support
stand 4 .
Putting into Operation
Switching On/Off
To put into operation , insert the plug into the mains
receptacle.
Place the gun on the support stand 4 (see Fig.
Allow the gun to heat up for approx. 7 min before be-
ginning work.
To switch off , pull the mains plug.
Allow the unit to cool completely before storing.
s
The hot nozzle can cause damage.
As the result of heat storage, the glue gun can also be
used after it has heated up without being connected to
the mains. If the glue that emerges becomes thick, in-
sert the plug into the mains receptacle again.
).
A