Inserting Paper; Safety Precautions And General Rules For Use - Olivetti Nettuna 7000 open Guide Rapide

INSERTING PAPER

Exclusively approved thermal paper should be used on the
Warning
cash register. If other types of thermal paper are used, in
particular paper that is too thin, the ticket may not be fed
correctly. Also the writing and logos on the back of the paper
must not be visible due to the transparency of the paper.

SAFETY PRECAUTIONS AND GENERAL RULES FOR USE

Note
before using the product, read this section carefully.

Make sure that the electrical specifications of the power unit used with the cash
register (230 V AC, 50/60 Hz) correspond with those of the mains power supply.

Connect the cash register to a standard-compliant electrical installation.

Do not expose the printer to direct sunlight, or install it near heat or water
sources, or in environments that are very damp or dusty.

Should smoke, odours or unusual noises be detected coming from the cash
register, disconnect it from the mains power supply and contact the Technical
Services desk.

To avoid the risk of injury, do not touch any of the parts indicated in these figures:
Cutter counterblade:
very sharp:

Do not pull the paper out of the output slot with the cover of the cash register
closed.

Do not open the cover of cash register while it is printing.

Do not carry out any other interventions on the cash register apart from those
described for problem resolution.

Do not attempt to disassemble or modify the product.
Warning
The procedures described in the following can be used when you
are inserting a paper roll on the cash register for the first time, or when replacing a
used paper roll. Paper rolls of widths 80 mm, 60 mm and 57.5 mm can be used on
the printer, however before using 57.5 and 60 mm rolls, you must first install the
paper roll Adapter Kit. When a paper roll must be replaced you are informed by a
message that appears on the monitor.
Printhead:
very hot
Automatic cutter blade:
very sharp
Manual cutter blade: very sharp
7