Horizon Hobby Spektrum AR400 Guide De L'utilisateur page 7

Plugging in the Leads
Plug the servo leads into the appropriate servo ports in the receiver, noting
the polarity of the servo connector.
BIND/DATA
(Bind, Data port)
THRO (Throttle port)
Binding
Binding is the process of programming the receiver of the control unit
to recognize the GUID (Globally Unique Identifier) code of a single specific
transmitter. You must bind the AR400 receiver to your transmitter before
it will operate.
1. To bind an AR400 to a DSM2 transmitter, insert the bind plug in the
BATT/BIND port on the receiver.
To bind an aircraft with an electronic speed controller that powers the
receiver through the throttle channel (ESC/BEC), insert the bind plug into
the BATT/BIND port in the receiver and the throttle lead into the THRO port.
2. Power on the receiver. The LED on the receiver will flash, indicating the
receiver is ready to be bound to the transmitter.
RUDD (Rudder port)
ELEV (Elevator port)
AILE (Aileron port)
EN
7