Toshiba Carrier RAV-SP180KRT-UL Manuel D'installation page 28

+001111052201_00Ta.book Page 27 Friday, November 20, 2009 11:45 AM
High-Wall Type
5
Procedure
1. Using temp. setup
specify CODE No. [14].
(CODE No. [14]: Group address)
2. Using timer time
the SET DATA from [0001] to [0002].
(SET DATA [Header unit: 0001] [Follower
unit: 0002])
3. Push button.
In this time, the setup finishes when the
display changes from flashing to lighting.
Indoor UNIT No. before setup change is displayed.
6
Procedure
If there is other indoor unit to be changed, repeat
2 5
procedure to to change the setup.
When the above setup has finished, push
to select the indoor UNIT No. before change of
setup, specify CODE No. [12], [13], [14] in order
with temp. setup
check the changed contents.
Address change check Before change:
[3-3-1] → After change: [2-2-2]
Pushing button clears the contents of which
setup was changed.
(In this case, procedure from
Indoor UNIT No. before setup change is displayed.
27-EN
/ buttons,
/ buttons, change
/ buttons, and then
2
is repeated.)
– 27 –
7
Procedure
After check of the changed contents, push
button. (Setup is determined.) When pushing
button, the display disappears and the status
becomes the usual stop status. (When pushing
button the operation from the remote controller is
not accepted for approx. 1 minute.)
* If the operation from the remote controller is not
accepted even 1 minute or more passed after
pushing button, it is considered that the
address setup is incorrect.
In this case, the automatic address must be
again set up.
Therefore repeat procedure of the setup change
1
from the Procedure .
To recognize the position of the
corresponding indoor unit though the
indoor UNIT No. is known
Check the position during operation stop.
(Be sure to stop operation of the set.)
1,3
Installation Manual
1
2
Toshiba