Bluetooth - Yamaha HTR-6230 Mode D'emploi

Troubleshooting
Problem
The desired station
cannot be tuned into
with the automatic
tuning method.
AM There are continuous
crackling and hissing
noises.
There are buzzing and
whining noises.
■
iPod
Note
• In case of a transmission error without a status message appearing on the front panel display, check the connection to your iPod (see page 14).
Status message
Connect error
Unknown iPod
iPod connected
Disconnected
■

Bluetooth

Status message
Searching...
Completed
Canceled
BT connected
Disconnected
No BT adapter
44
En
Cause
The signal is weak or the antenna
connections are loose.
Noises result from lightning,
fluorescent lamps, motors, thermostats
and other electrical equipment.
A TV set is being used nearby.
Cause
There is a problem with the signal path
from your iPod to this unit.
The iPod being used is not supported by
this unit.
Your iPod is properly stationed in a
Yamaha iPod universal dock (such as
YDS-11, sold separately) connected to the
DOCK terminal of this unit, and the
connection between your iPod and this
unit is complete.
Your iPod was removed from a Yamaha
iPod universal dock (such as YDS-11,
sold separately) connected to the DOCK
terminal of this unit.
Cause
The Bluetooth receiver and the Bluetooth
component is in the middle of the pairing.
The Bluetooth receiver and the Bluetooth
component is in the middle of establishing
the connection.
The paring is completed.
The paring is canceled.
The connection between the Bluetooth
Wireless Audio Receiver (such as YBA-
10, sold separately) and the Bluetooth
component is established.
The Bluetooth component is disconnected
from the Bluetooth receiver (such as
YBA-10, sold separately).
The Bluetooth receiver is not connected to
the DOCK terminal.
Remedy
Tighten the AM loop antenna connections and
orient it for the best reception.
Use the manual tuning method.
Use an outdoor antenna and a ground wire.
This will help somewhat, but it is difficult to
eliminate all noise.
Move this unit away from the TV set.
Remedy
Turn off this unit and reconnect the Yamaha iPod
universal dock to the DOCK terminal of this unit.
Try resetting your iPod.
Only iPod (Click and Wheel), iPod nano, and iPod
mini are supported.
Station your iPod back in a Yamaha iPod universal
dock (such as YDS-11, sold separately) connected to
the DOCK terminal of this unit.
Remedy
Connect the Bluetooth Wireless Audio Receiver (such
as YBA-10, sold separately) to the DOCK terminal.
See
page
—
27
—
—
See
page
14
—
—
14
See
page
14