Dixon Bayco BALL NOZZLES Manuel D'installation & Mode D'emploi page 6

of the spout adapter (48A/48B) (or swivel nut adapter [46]) and thread into the body (1). Use
a wrench to tighten snug; do not over tighten.
 Next secure the ball nozzle in a bench vice with the inlet end pointing vertically up; this
will prevent loose internal components from falling out.
 Then remove the inlet swivel assembly; DO NOT use a pipe wrench, which can cause
distortion of the swivel body (20) and possible leakage. A spanner or crescent wrench is
recommended. Using a pipe wrench WILL VOID WARRANTY.
 Make sure the actuating lever (6) is in the closed position (inline with ball nozzle body);
then remove two wave springs (19), washer (18), ball follower (17), ball (16), ball seal
(15), and o-ring (14).
 Remove the pin (11) from the actuating lever (6); remove the lever from the stuffing box
shaft (5).
 Remove the stuffing box as follows: push the shaft (5) into the ball nozzle body (1) and
remove it through the body inlet end; remove nut with wrenching tool (eg. steel bar 1/8"
x 1/2" x 3").
 Replace the two shaft o-rings (4), and the nut o-ring (3); reinstall the stuffing box
assembly in reverse order; apply a removable thread locker such as Loctite 242 to the nut
(2); tighten the nut (2) until it bottoms out against the ball nozzle body (1).
 Reinstall the old lever (6) with the old pin (11); rotate the pin (11) 90 degrees from its
original position to ensure a secure press fit.
 Replace ball seal o-ring (14), ball seal (15), ball follower (17), and inlet o-ring (35).
 Reinstall remaining components in reverse order; apply a removable thread locker such
as Loctite 242 to the male threads of the swivel body (20) and thread into the body (1).
Use a crescent wrench (NOT a pipe wrench) to tighten until swivel body (20) bottoms out
against ball nozzle body (1).
DIXON BAYCO WARRANTY:
inside back cover of the latest Dixon Catalogue.
For complete Warranty information, please refer to the
6 090100 R8