Important; Safety Note - Dixon Bayco BALL NOZZLES Manuel D'installation & Mode D'emploi

To properly operate and maintain your DIXON BAYCO ball nozzle the

IMPORTANT:

following instructions are provided. Please read with care as improper handling or
maintenance may cause a hazardous condition.
Do not modify your DIXON BAYCO ball nozzle for any reason. It could result in
CAUTION:
a hazardous condition due to operating difficulties or malfunction. Disassembly or tampering
will void the product warranty.

SAFETY NOTE:

 Nozzle must be attended when filling tank. Never leave nozzle unattended.
 Never smoke or allow an open flame near your dispenser when handling volatile
materials such as gasoline or fuels. An explosion could result.
 Immediately remove from service any ball nozzle that is not performing
satisfactorily.
 Do not drag nozzle across rough surfaces.
 Remember safety is everyone's business.
DIXON BAYCO ball nozzles are properly adjusted, tested and ready to use
Installation:
upon leaving the factory. When connecting the nozzle to the pump hose, apply a thin layer of
a suitable thread sealant (such as DIXON "LCTS 1") to the male threads on the hose fitting
or swivel; using a spanner or crescent wrench tighten snugly. (To avoid damage to the
nozzle & fitting, do not use an Adjustable Pipe Wrench, and take care not to over tighten the
treads.)
The nozzle spout should be inserted as far as possible into the fill-pipe. If
How to Use:
equipped with a swivel nut adapter, thread the swivel nut securely onto the fill-pipe adapter
to ensure a leak-proof connection. Never leave nozzle unattended, these nozzles are designed
for bulk delivery and do not have an auto-shut off mechanism.
Flow rate is activated and increased as the trigger is rotated in either direction from the
closed position. Maximum flow rate is achieved when lever is at 90 deg to closed position.
Lower flow settings are recommended for "hard to fill" conditions, such as when "topping-
off" or splashing may occur.
Inspect for Damage:
damaged, loose or missing parts. Please see back page for available repair kits.
Check for Loose Adapters:
swivel nut adapter) to the body outlet. Also check the connection of the inlet swivel
assembly to the body. These connections should be tight. If found to be loose, reinstall the
component using a removable thread-locking product such as Loctite 242. Tighten with care.
Avoid excessive force, which can damage the nozzle body or the mating component.
Ball nozzles can fail if not properly maintained. Frequently check for
Occasionally check the connection of the spout adapter (or
2 090100 R8