General Safety Information; Packing Contents - AgfaPhoto AF5089 Guide De Démarrage Rapide

General Safety Information

· General Safety Information
Introduction 2
Do not make any changes or settings that are not de-
scribed in this user manual. Physical injury or damage
to the device or loss of data can result from improper
handling. Take note of all warning and safety notes in-
dicated.
The device is exclusively for indoor use.
The device is exclusively for indoor use. The device
should be placed securely on a stable, flat surface. Po-
sition all cables in such a way that no one will stumble
on them, thus avoiding possible injuries to persons or
damage to the device itself.
LCD screen
Always handle the unit with care. Avoid touching the
LCD screen. Never place heavy or sharp objects on the
LCD panel, frame or power cord.
Protect the device against direct sunlight
Protect the device against direct sunlight, heat, large
temperature fluctuations and moisture. Do not place
the device in the vicinity of heaters or air conditioners.
Observe the information on temperature and humidity
in the technical data.
Do not switch the device on immediately after transporting it.
The device should not be switched on immediately af-
ter being moved from a cold to a warm room or vice ver-
sa or into a cold room which has been heated up
quickly. In such cases, wait at least three hours until
the device has adapted to the changed conditions
(temperature, humidity...) .
In the event that the device becomes too hot, or if you see smoke coming from the device
In the event that the device becomes too hot, or if you
see smoke coming from the device, you must immedi-
ately pull the power cable out of the power socket.
Have your device examined by trained professionals at
a technical service location. To prevent the spread of
fire, open flames should be kept away from the device.
Do not plug in the device in moist rooms.
Do not plug in the device in moist rooms. Never touch
the mains cable or the mains connection with wet
hands.
Do not allow liquids to enter into the device.
Do not allow liquids to enter into the device. Disconnect
the device from the power socket if liquids or foreign
objects have entered the device and have your device
examined by trained professionals at a technical serv-
ice location.
Do not allow children to handle the device without supervision.
Do not allow children to handle the device without su-
pervision. The packing materials should be kept out of
the hands of children.
Use only the enclosed power adapter
Use only the enclosed power adapter (see chapter Ap-
pendix / Technical Data). Check whether the mains volt-
age of the power supply matches the mains voltage
available at the setup location. This equipment com-
plies with the voltage type specified on the unit.
Never touch the power cable if the insulation is damaged.
Never touch the power cable if the insulation is dam-
aged. Replace damaged wires immediately. Use suita-
ble cables only; if necessary please contact our
technical customer service or your retailer.
Before cleaning the surface of your device, disconnect it from the power network.
Before cleaning the surface of your device, disconnect
it from the power network. Use a soft, lint-free cloth.
Never use liquid, gaseous or easily flammable cleans-
ers (sprays, abrasives, polishes, alcohol). Do not allow
any moisture to reach the interior of the device.
Only clean the display with a dry, soft cloth.
Only clean the display with a dry, soft cloth. If the dis-
play breaks, a mildly corrosive liquid may escape. Avoid
all contact with your skin and eyes.
Repairs
Do not make any repairs to the device yourself. Improp-
er maintenance can result in injuries or damage to the
device. Only have your device repaired by an authorised
service centre.
Do not remove the type label from your device; this
would void the warranty.
Photo Memory Media
Only use storage media that are compatible with the
device. In order to prevent damage to the card or the
unit, please turn off the power before removing or in-
serting the card.
Never pull out the memory card while the device is ac-
cessing it. This could cause data to be damaged or lost.

Packing Contents

· Packing Contents
•) Digital photo frame with bracket
•) Power supply with exchangeable plugs
•) Quick Start Guide
•) Warranty card
Basic Operation (fig. 1)
· Basic Operation (fig. 1)
1. If there is a protective foil on the frame, please re-
move it before attempting to use.
2. Insert a memory card or a USB storage medium into
the appropriate slot at the rear of the device. Your
device supports the following memory cards:
SD/SDHC/MMC/MS/XD.
Take note of the correct insertion
direction!
The memory card can only be inserted in
one direction. Do not force the card into the
slot.
3. Insert the small plug of the power supply into the
socket Í on the rear side of your device.
4. Plug the power supply into the mains. The player
will start slide show after the start screen be dis-
played.
Buttons on the Reverse Side of the
Device (fig. 2)
· Buttons on the Reverse Side of the Device (fig. 2)
À/Á—Navigating in the Menu / Skips to the previous
or next image.
¡/¢—Navigating in the Menu
à—Confirms the selection / Starting, interrupting the
slide show
EN
3