Care And Maintenance - GeneralAire Elite Serie Mode D'emploi

Table des Matières

Les langues disponibles

900-9 NOZZLE

900-10 SPOUT

This humidifier, if properly registered by the return of the warranty registration card to the manufacturer, is warranted to the consumer against defects in

materials and workmanship for a period of ten years from the date of installation. Evaporator pads, water strainers or metering orifices are not covered by

this limited warranty or any other warranties. Any other defective parts will be repaired without charge except for removal, reinstallation and

transportation costs. To obtain repair service under this limited warranty, the consumer must send the defective part or the complete humidifier to the

manufacturer.

THERE ARE NO EXPRESS WARRANTIES COVERING THIS AIR CLEANER OTHER THAN AS SET FORTH ABOVE, THE IMPLIED WARRANTIES OF

MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE EXPRESSLY EXCLUDED. THE MANUFACTURER ASSUMES NO

LIABILITY IN CONNECTION WITH THE INSTALLATION OR USE OF THIS PRODUCT, EXCEPT AS STATED IN THIS LIMITED WARRANTY. THE

MANUFACTURER WILL IN NO EVENT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES.

This limited warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Some states do not allow either

limitations on implied warranties, or exclusions from incidental or consequential damages, so the above exclusion and limitation may not apply to you.

Any questions pertaining to this limited warranty should be addressed to the manufacturer. (U.S.A.: The manufacturer has elected not to make available

the informal dispute settlement mechanism which is specified in the Magnuson-Moss Warranty Act.)

Your Humidifier is engineered to give helpful and trouble-free humidification. For maximum efficiency the following cleaning procedures should be carried

out at the end of each heating season:

1. Turn off water supply and electrical power to humidifier.

2. Remove cover, water distributor trough, evaporator pad, pad rails and drain pan. Clean excessive mineral

deposits from the distributor trough, drain pan, pad rails and humidifier cabinet. A solution of 1/2 vinegar & 1/2

water will help loosen mineral deposits. Inspect drain hose, clean or replace as necessary.

3. Replace humidifier evaporator pad if necessary. (Part number GA19) Install trough, pad rails and drain pan.

Replace cover, reconnect electrical plug. Replace evaporator pad yearly for peak performance.

4. In heavy mineral areas or if the solenoid valve fails to function disconnect the 1/4" water supply line from the

solenoid valve. Carefully pull the strainer screen (P.N. 900-8) from the valve body (P.N. 900-6). Clean the

mineral deposits from all parts. If the orifice is clogged, it may be opened by inserting a small pin. Reinsert

the filter into the valve body.

5. Reconnect the 1/4" water line to the solenoid valve if necessary. Turn on the water supply and check all points

for leakage. The operation of the unit may be checked by starting the furnace. The humidifier operates only

when the furnace blower is running or the burner circuit is energized. The humidifier is now ready for

operation.

6. During the summer, turn off water supply and electrical power to humidifier.

PARTS LIST FOR HUMIDIFIER

900-40 PAD RAIL

GA19 EVAPORATOR PAD

900-15 DISTRIBUTOR TROUGH

GA4247 FAN BLADE

900-14 DRAIN PAN

GA4231 ORIFICE - YELLOW

P-190 COMPRESSION SLEEVE (PLASTIC)/P102 COPMRESSION SLEEVE (BRASS)

P-101 COMPRESSION NUT

GA4235 DISTRIBUTOR TUBE

P-189 TUBE SUPPORT

P-101 COMPRESSION NUT

P-102 COMPRESSION SLEEVE (BRASS) OR

P-190 COMPRESSION SLEEVE (PLASTIC)

GA4004 STRAINER SCREEN

GA4045 SOLENOID & HARNESS

ASSEMBLY

LIMITED WARRANTY