Care And Maintenance - GeneralAire 570 Serie Manuel D'instructions

Masquer les pouces

Table des Matières

Les langues disponibles

570-1 CHASSIS

900-9 NOZZLE

900-10 SPOUT

GA4226 DISTRIBUTOR TUBE

GA4040 SOLENOID VALVE ASM

GA4004 STAINER SCREEN

P102 COMPRESSION SLEEVE

P101 COMPRESSION NUT

P189 BRASS TUBE INSERT

747-38 TUBING KIT (AVAILABLE)

This humidifier, if properly registered by the return of the warranty registration card to the manufacturer, is warranted to the consumer against defects in

materials and workmanship for a period of ten years from the date of installation. Evaporator pads, water strainers or metering orifices are not covered by this

limited warranty or any other warranties. Any other defective parts will be repaired without charge except for removal, reinstallation and transportation costs.

To obtain repair service under this limited warranty, the consumer must send the defective part or the complete humidifier to the manufacturer.

THERE ARE NO EXPRESS WARRANTIES COVERING THIS HUMIDIFIER OTHER THAN AS SET FORTH ABOVE, THE IMPLIED WARRANTIES OF

MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE EXPRESSLY EXCLUDED. THE MANUFACTURER ASSUMES NO LIABILITY IN

CONNECTION WITH THE INSTALLATION OR USE OF THIS PRODUCT, EXCEPT AS STATED IN THIS LIMITED WARRANTY. THE MANUFACTURER

WILL IN NO EVENT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES.

This limited warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Some states do not allow either

limitations on implied warranties, or exclusions from incidental or consequential damages, so the above exclusion and limitation may not apply to you.

Any questions pertaining to this limited warranty should be addressed to the manufacturer. (U.S.A.: The manufacturer has elected not to make available the

informal dispute settlement mechanism which is specified in the Magnuson-Moss Warranty Act.)

Your humidifier is engineered to give helpful and trouble-free humidification. For maximum efficiency the following cleaning procedures should be carried out at

the end of each heating season:

1. Turn off water supply and electrical power to humidifier.

2. Remove water cover, distributor trough, evaporator pad and drain pan. Clean excessive mineral deposits from the

distributor trough, drain pan, pad rails, and humidifier cabinet. A solution of 1/2 vinegar & 1/2 water will help loosen mineral

deposits.

Replace humidifier evaporator pad if necessary. (Part number GA10) Install trough and drain pan.

Replace cover. Replace evaporator pad yearly for peak performance.

4. In heavy mineral areas or if the solenoid valve fails to function disconnect the 1/4" water supply line from the solenoid valve.

Carefully pull the strainer screen (P.N. GA4004) from the valve body (P.N. 900-6). Clean the mineral deposits from all

parts. If the orifice is clogged, it may be opened by inserting a small pin. Reinsert the filter into the orifice fitting and screw

the brass strainer body into the solenoid valve.

5. Reconnect the 1/4" water line to the solenoid valve if necessary. Turn on the water supply and check all points for leakage.

The operation of the unit may be checked by starting the furnace. The humidifier operates only when the furnace blower is

running or the burner circuit is energized. The humidifier is now ready for operation.

6. During the summer, turn off water supply and electrical power to humidifier. Close air damper.

PARTS LIST FOR HUMIDIFIER

570-40 PAD RAIL

GA-10 EVAPORATOR PAD

900-15 DISTRIBUTOR TROUGH

900-14 DRAIN PAN

GA4231 YELLOW ORIFICE

P190 COMP. SLEEVE (PLASTIC)/P102 COMP. SLEEVE (BRASS)

P101 COMPRESSION NUT

LIMITED WARRANTY