Assembling The Motor - FAAC TM2 PP Mode D'emploi

ASSEMBLING THE MOTOR

RING NUT
1
2
3
NB: If the tube has a circular section, the drive pulley must be fastened to the tube.
This must be carried out by the installer. For other types of profile, it is optional to
fasten it to the tube, even if it is strongly recommended to do so.
TM2 PP
RING NUT ADAPTER
1. Insert the adapter onto the ring nut so
that the groove is lined up with the refer-
ence mark and push it on as far as it will go.
2. Install the drive pulley on the shaft of
the motor until the detent spring clicks.
3. Insert the motor completely into the
winding tube.
8
DRIVE PULLEY
A4518_6G82_Rev.A