Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Control Panel
Chop
Variable
Pulse
Power Requirements
Use a fused electric outlet for the blender. Depending on the model of your blender, the plug will look like
the following to meet power requirements:
Blender Operation – Quick Start Guide
1.
Read Important Safety Instructions and Warnings
before use.
2.
Place the blender on a dry, level surface.
3.
Make sure the Power/Reset switch is set to
OFF (O), and the Standby/ON (I) switch is set
to STOP
. Plug the blender into a grounded
3-prong electrical outlet.
4.
Place the container on the base with ingredients
and container lid in place.
Variable Speed Knob
120 VAC, 60 Hz
Ground
prong
5.
Turn the Power/Reset switch on the rear of the
base to the RESET position.
6.
Adjust the variable speed knob to desired speed.
7.
Set the Standby/ON (I) switch to START
use PULSE
Start
Standby/ON (I)
Stop
.
or
5
Publicité
Table des Matières
Dépannage
