Greenlee Marker-Mate EML100 Manuel D'instructions page 8

MENU Key
Note: The EML100 is active as soon as it is turned on and completes the Power-On
Sequence. The bottom line of text on the display shows available options when using the
MENU key.
Press the MENU key to cycle through the following sub-menus:
Volume Control
Use the s or t key to select Off, Low, Medium, or High; and use the EXIT key to exit the
MENU screen (Figure 4).
Pressing the MENU key again will display the MODE Select menu.
Mode Select
Use the s or t key to select from the following modes, and use the EXIT key to exit the
MENU screen (Figures 5 and 6).
Note: The modes are listed in the order they appear on the display. The t key must be
used to change the mode from SCAN, and the s key must be used to change the mode
from NON-PTBL.
POWER
MODE SCAN
Figure 5. SCAN Mode
Pressing the MENU key again will display the POWER Save menu.
Power Save Timer
The Power Save Timer may be de-activated, or set in 15-minute increments to automati-
cally turn the unit off.
Use the s or t key to select 60, 45, 30, 15 minutes, or Off; and use the EXIT key to exit
the MENU screen (Figure 7).
Pressing the MENU key again will display the BATTERY menu.
Battery Life
This selection displays the estimated Battery Life remaining in percentage (Figure 8).
Press the EXIT key to exit the MENU screen.
8
NON-PTBL
VOLUME
Figure 4. Volume Control
xx
GAS
POWER SAVE
Figure 7. Power Save Off
GAS
BATTERY xx %
Figure 8. Battery Life
xx
xxx
POWER
MODE POWER
Figure 6. Power Mode
xx
xx MIN
xx
xx