Greenlee Marker-Mate EML100 Manuel D'instructions page 11

Scan Operation
To locate all compatible markers using the SCAN mode:
1. Perform steps 1 through 6 under "Normal Operation" above.
2. Press EXIT to enter the SCAN mode and locate all compatible markers.
3. Press the EXIT key repeatedly to toggle between the SCAN mode and a specific marker
type mode.
Note: In SCAN mode, the EML100 will display the readings for the strongest signal being
received.
Pinpoint Feature
The Pinpoint feature is used to adjust the gain of the EML100 to more closely locate a
marker.
Gain adjust:
• To eliminate noise or pinpoint markers, reduce gain by pressing the LO gain button.
• Display indicates gain setting relative to 100%.
• Continue pressing LO gain to reduce gain.
• Press the HI gain button to restore gain to 100%.
Note: Press the LO gain button away from the marker peak signal for best pinpoint result.
Note: The Pinpoint feature will work in both normal operation and SCAN modes.
NORMAL DISPLAYS
GAS 35
GAS 0 65%
EML100 Top View
Figure 14. Pinpoint Feature
GAS 98
GAS 65 65%
PINPOINT DISPLAYS
AFTER PRESSING
THE ▼ KEY.
Note the % reading.
OMNI MARKER
EML100
11