Tools And Accessories; Technical Information; Spare Parts - Carat S-1802 Mode D'emploi

S-1802/S-1803
5.2 Adjust and replace slide blocks
Because of friction between the slide blocks and the column, the slide blocks will wear. After a while
this will lead to a lower stability.
The tolerance can be repaired on this way:
1. Unscrew (3) with the pin-face wrench
2. Turn in the set screw until the friction is gone.
3. Tighten screw 3 again.
When it is not possible anymore to adjust the slide blocks
can be replaced. Remove the screw (3) and (2) and
replace the slide blocks.
5.3 Removing materials
Because of environ-requests you have to consider the current rules for this. In case of an non
replaceable spare part, these has to be flown out by the concerned organisation. All the additional
costs are for own account.

6. TOOLS AND ACCESSORIES

The machines contain the following tools:
Spare part
Pin-face wrench
Pin-face wrench
Pin-face wrench
Pin-face wrench
Manual
The bellowed accessories can separately be ordered:
Spare part
Water collector
Vacuum set
Telescopic punch

7. TECHNICAL INFORMATION

7.1 Sizes
Length : 448.5 mm
Width : 230 mm
Height : 840 mm
Weight : 7,5 kg
7.2 Technical information
Motor installation
Drill with water collecting ring
Drill without water collecting ring: Ø 150 mm
Length drill

8. SPARE PARTS

Separate spare parts can be ordered in view of the explosion view and spare part list.
Always indicate the series and type number of the support which you can find on the type plate.
8.1 Spare parts
29-2-2012
Description
SW5
SW6
SW8
SW 17 – 19
Drilling support S-1801
Description
Max. drilling Ø 130 mm
Vacuum block and rubber for base
plate
For extra locking between ceiling and
support
: Ø 60 mm
: Ø 130 mm
: max 400 mm
13 CARAT S-1802/S-1803