Using The Machine - Carat S-1802 Mode D'emploi

S-1802/S-1803
The column is oblique adjustable by loosen the 2 bolts (14) and disassemble bolt (16), than turn the
column over into the desired position and tighten the bolts (14) again. When the column must be
adjusted again, than replace the bolt (16) again.

4. USING THE MACHINE

Step 1. Anchor by using a quick-acting screw or clamping plate.

Attach the anchor M12 in floor or wall.

Turn the threaded end of the quick acting screw in the anchor.

Set the base plate over the threaded end and fasten the quick-acting nut.
Step 1a. Anchoring by using the vacuum (option)
(not suitable on for instance: porous undergrounds,
wallpaper, stucco work, tiles, linoleum)

Equalize and clean the underground

Assemble the vacuum block and the sealing rubber

Fix the plate at the underground and level it.

Connect the vacuum pump to the coupling.

After existing vacuum, the pump must be on. (To have
Sufficient underpressure, the manometer must between
0.7 and –1)
To switch off the pump and open the air relief cock to stop the
Vacuum.
Step 2. Set level
Setting the plate level by using the set bolt. For a floor mounting there is libelle and a wall mounting.
There is a water level mounted in the support.
Step 3. Motor and water supply/ discharge.

Turn the support to the highest position.

Fasten the drill with extension pieces on the threaded spindle of the motor.

Attach the water hose between the water tap and the coupling piece. Then open the tap.
(Don't use dirty water)

Always safely discharge the water by using a water cleaner leads, plug and electricity may not
touch the water.

A water collection ring must be used when drilling above the head.

Check if everything is properly fastened and follow the safety advices.

As extra anchoring a telescopic punch can be placed between column base plate and
ceiling/wall.
00
Well check and execute the above mentioned points.
5. MAINTENANCE
5.1 General
Beside a regular maintenance (see next section), the safety and lifetime of the machine can be
enlarged by considering the following points.

Threat the machine with care

Regular clean the complete support.
29-2-2012 12 CARAT S-1802/S-1803