Fault - Angelo Po 0G0FT1E Manuel D'utilisation Et D'installation

Caution - warning
Clean the plate appropriately, using the op-
tional equipment available.
To carry out this operation,
proceed as follows.
1 - Use the scraper tool (A)
to remove cooking resi-
dues from the plate.
N.B.: use a notched-blade
utensil (B) for appliances
with ribbed plates.
2 - Spread a suitable de-
greaser on the plate
and leave it to act for a
few minutes.
3 - Plug the drain hole
(C).
4 - Pour water at 60°C onto the plate and
leave it to soak for a few minutes.
5 - Remove the drip tray (D) and place a
bucket underneath the drain hole.
6 - Remove the plug (C) to drain the water
from the plate.
7 - Clean the plate thoroughly with a sponge, rinse
with plenty of water and dry.
IT
GB
DE
The appliance has been tested before being put into
service. The information provided below is intended
FR
to assist in the identification and correction of any
anomalies and malfunctions which might occur during
ES
use. The user can solve some of these problems him-

Fault

The heating elements do not
come on.
English
CLEANING THE PLATE
A
TROUBLESHOOTING
Electrical connection not made
Safety thermostat tripped.
Important
When cleaning, use only food-approved de-
tergents.
C
B
Important
Rinse the cooking plate thoroughly to re-
move all residues of the degreasing deter-
gent, and prevent stains and marks from
forming when the plate is put back into use.
FAULT
self, but for others specific technical knowledge or skill
is required, and so they must only be carried out by
qualified staff with recognised experience acquired in
the specific sector of operation.
Causes
correctly.
Switch faulty.
- 10 -
D
Remedies
Check the connection of the
electrical wires.
Carry out the appliance reset
(see page 15).
Replace the switch
Important
Contact the after-sales service.
C
IDM-39603604200.tif
6