Nice Planotime Instructions Et Recommandations Pour L'installation page 16

5.2.2) Programmazione: modifica eventi MOD
All programmed events can be modified at any time. Before modifications, an event must be located and selected
from all those present.
Table 25 Modifying an event:
1. Press key
2. Press key
3. Press key
4. Press key
5. Press key
6. Press key
7. Press key
chronologically according to the order in which they are performed, starting from
the most recent; press
8. Press key
From this point onwards, modifications are performed according to the same procedure as described for programming
a new event (see chapter 5.2.1) and all properties can be modified or confirmed individually as required. After modi-
fying and confirming the last parameter, the event is memorised again and PLANOTIME is ready for modification of
another event, in which case proceed from point 16 of this table.
5.2.3) Programming: deleting events DEL
All programmed events can be deleted at any time. Before deleting, an event must be located and selected from all
those present.
Table 26 Deleting an event:
1. Press key
2. Press key
3. Press key
4. Press key
5. Press key
6. Press key
7. Press key
chronologically according to the order in which they are performed, starting from
the most recent; press
8. Press key
9. Press key
press key
After deleting an event, PLANOTIME is ready for subsequent deletion of another event; in this case proceed from point
N°6 of this table.
16
repeatedly until the text Auto starts flashing
three times to select programming mode Prog
to confirm programming mode
to confirm events programming
to select events modification MOD
to confirm events modification
or to select the event to modify. Events are displayed
to move to the next event, or
to confirm the selected event
repeatedly until the text Auto starts flashing
three times to select programming mode Prog
to confirm programming mode
to confirm events programming
twice to select event deletion DEL
to confirm event deletion
or to select the event to delete. Events are displayed
to move to the next event, or
to confirm the selected event
to confirm deletion of the selected event. To exit without deleting,
and resume the procedure from point 7 in this table.
to move to the previous.
to move to the previous.
Example
... Auto
or
Example
... Auto
or