5 How To Program Planotime; 5.1 Selecting The Type Of Programming; 5.1.1 Forward And Backward For Programming - Nice Planotime Instructions Et Recommandations Pour L'installation

5) How to program PLANOTIME
The operation of PLANOTIME in the "programming" mode allows you to program, modify, copy and delete events;
you can also set the timer and the other parameters that are useful for the operation of PLANOTIME.
Prog Programming the "events" (see chapter 5.2)
When programming the "events", you can:
NEW Enter a new event, establishing all its properties one by one
MOD Modify an event by changing one or more of its properties
COPY Copy an event in order to create a new one starting from the properties of the pre-existing event
DEL Delete an event, eliminating it completely
Prog Setting the timer (see chapter 5.3)
The timer has to be set in order to enable PLANOTIME to execute the events at the established time. If the special
"planetary time" command is used, in addition to the hours, minutes and day of the week you also need to set the
day of the month, the month and the year and, finally, you must specify whether the current time is winter (sun time)
or summer (legal time).
Prog Setting the "holiday" parameters (see chapter 5.4)
This function allows you to set the maximum permissible shifting of the event from the established time. It can range
from a minimum of 0 minutes (no shifting) to a maximum of 75 minutes earlier or later than the established time.
Prog Setting the "planetary time" parameters (see chapter 5.5)
This function allows you to set the parameters needed for calculation of the "planetary time":
• Latitude of your position with respect to the Equator (shown in all maps).
• Difference between the time indicated by the clock and the actual sun time
• Specify whether the current time is winter (sun time) or summer (legal time).
5.1) Selecting the type of programming
To access the "programming" mode you need to select and confirm it in the "selection menu".
The selection menu can be considered as the starting point for all the PLANOTIME functions.
From any of PLANOTIME's operating or programming modes, you can return to the "selection menu" by repeatedly
pressing key until "Auto" starts flashing.
5.1.1) Forward and backward for programming
The programming process features a series of stages that include all the necessary settings or parameters.
Please keep in mind that during this process:
• The symbol that flashes at 50% refers to the parameter being programmed, i.e. the current stage
• Keys and are used to adjust the current parameter
• Key is used to confirm the parameter and proceed to the next stage
• Key is used to cancel your selection and return to the previous stage
• Key is used to select or deselect a parameter
• If a symbol flashes at 25%, it means that the parameter has not been selected
• If a symbol flashes at 75%, it means that the parameter has been selected
• In some cases it is not possible to confirm a parameter unless a selection has been made, for example, it is not
possible to program an event unless you have selected at least a day of the week.
12