Replacing The Light Bulb - De Dietrich DOP 8360 G Guide D'utilisation

4
•
CARE
DELAYED CLEANING (fig. F)
Follow the instructions in the previous
paragraph and then set the end time
for the pyrolysis cycle by pressing
The display flashes. Set the end time
with + and - . After these steps, the
start of pyrolysis is delayed so that it
finishes at the programmed time. When
the pyrolysis cycle has finished, put the
function selector back to 0.
REPLACING THE LIGHT BULB (fig. G)
Warning
Make sure the appliance is
disconnected from the power before
replacing the bulb in order to avoid
the risk of electric shock. Carry out
the operation when the appliance has
cooled.
Bulb specification:
25 W, 220-240 V~, 300°C, G9.
You can replace the bulb yourself.
Unscrew the view port and remove the
bulb (use a rubber glove, which will make
it easier to remove). Insert the new bulb
and replace the view port.
.
20