Greenlee C3 Auto Whip Manuel D'instructions page 4

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

IMPORTANT SAFETY INFORMATION
• Keep guards in place and in
working order.
• Do not tamper or attempt to bypass
safety switches.
• Remove any tools from cutter
before operating. Form habit of
checking to see that all tools are
removed from cutter before turning
it on.
Failure to observe these warnings
could result in severe injury or death.
Extension cords:
• Use only three-wire, 12 AWG exten-
sion cords that have three-prong
grounding-type plugs and three-
hole receptacles that accept the
tool's plug.
• Do not use extension cords that are
longer than 30 m (100').
• Repair or replace damaged exten-
sion cords.
Failure to observe these warnings
could result in severe injury or death.
Cutting hazard:
Keep hands away from the cutting
blades when cutting.
Failure to observe these warnings
could result in severe injury or death.
Greenlee Tools, Inc.
C3 Auto Whip Clad Cable Cutter
• Reduce the risk of unintentional starting. Make sure
switch is in off position before plugging in.
• Turn power off. Do not leave tool until it comes to a
complete stop.
• Disconnect tool when changing feed roller or
Notching Blade, or cut off blade. Accidental start-
up could result in serious injury.
Failure to observe these warnings could result in
severe injury or death.
• Never stand on tool. Serious injury could occur if
the tool is tipped.
• Do not overreach. Keep proper footing and balance
at all times.
Failure to observe these warnings could result in
severe injury or death.
• Wear proper apparel. Do not wear loose clothing,
gloves, neckties, rings, bracelets, or other jewelry
which may get caught in moving parts. Nonslip
footwear is recommended. Wear protective hair
covering to contain long hair.
• Do not force rollers or alter tool. It will do the
job better and safer at the rate for which it was
designed.
• Use right tool. Do not force tool or attachment to do
a job for which it was not designed.
• Use this tool for the manufacturer's intended
purpose only. Use other than instructed in this
manual can result in injury or property damage.
Failure to observe these precautions may result in
injury or property damage.
4
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070

Publicité

Table des Matières
loading

Table des Matières