Greenlee C3 Auto Whip Manuel D'instructions page 24

Operation (con't)
(Figure 9)
b. Touch Specify Whip Configuration on the
Specify Cable Type and Whip Parameters screen
(Figure 10).
c. Touch USB Import on the Whip Configuration
screen (Figure 12).
d. The display will show the USB Data Import –
Whip Config screen (Figure 40). Touch the light
green Select CSV File box.
e. The display will show the CSV files stored in the
flash drive. Select the desired CSV file and press
Enter. The CSV file name will appear in the light
green File Name Selected box.
f. Touch the green Load Data box to begin the
transfer. The Read Activity button will flash
green to indicate the transfer is occurring.
g. The Read Complete button will turn green
when the transfer is complete. Touch the < to
complete the selection and return to the Whip
Configuration screen.
h. Select the desired whip configurations by
touching the Single Job box or Multi Job box
and the Job # box adjacent to the desired whip
configurations and the Load Jobs box. Both
boxes will turn yellow and the Load Jobs box
will momentarily turn yellow to indicate the
selection (Figure 12 & 13). Press the < to
complete the selection and return to the
previous screen.
Figure 40
Greenlee Tools, Inc.
C3 Auto Whip Clad Cable Cutter
24
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070