Operation; Lcd-Display - EuroLite NB-150 ICE Mode D'emploi

Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.

OPERATION

Connect the remote control with the Remote Control-socket. Switch the device on via the power switch.

LCD-Display

After a certain warm-up time, the device is ready to operate. When the machine is ready for fogging, the
display shows "OK" below the display line HEAT. By pressing the Output-button on the remote control the
smoke emission starts. It may happen that the the display below the line HEAT flashes. In this case the
device is heating up again and will be ready to operate in approx. 1-2 min. This process guarantees an
appropriate vaporization temperature and the best smoke emission possible. The temperature is regulated
by a high quality thermostat.
The remote control's interface allows the operator to customize fog machine functions by adjusting fogging
duration, interval and volume. Its LCD displays current operating parameters, which are automatically stored
in non-volatile memory, allowing the machine to be powered down without losing function settings.
Instructions below:
International
L
N
18/40 00033330.DOC, Version 1.1