GRAUPNER ULTRA TRIO PLUS 16 Instructions D'utilisation page 43

T y p e O U T P U T[ 1 ]
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
L i P o = 3 c e l l s
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
+
-
INC
DEC
! Caution ! Please take great care
to set the correct cell count and
battery type. If you make a mi-
stake, the battery could explode
and burst into fl ames !
L i t h i u m t y p e
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2 sec.
L i P o 4 . 2 0 V / C
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
+ -
INC
DEC
ENTER
Lithium cell count
When you have connected the battery to the charger, hold
the START button pressed in for about two seconds and the
screen will display the cell count of the Lithium pack. If the pack
contains 1 or 2 cells, the charger detects and sets the number
of cells fully automatically. If the pack contains more than two
cells, you may have to adjust the cell count manually using the
INC / DEC buttons, as the automatic circuit is unable to detect
more than three cells reliably. On the right-hand side you will
see the voltage of the pack connected to the charger. Pressing
the START button again initiates the charge process.
Lithium type select program
This is actually the most important set-up program for Lithium
batteries. In the Select program you enter the battery type and
battery capacity. It is vital to enter this information with the greatest
care. Check it very thoroughly, as the charger derives all the other
charge parameters from the settings you enter here.The battery
type you select (LiPo, LiIo or LiFe) affects the charge termination
voltage. If you fi nd that a Lithium battery has unexpectedly been
charged only to the 2/3 full mark, you have probably set the in-
correct battery type at this point.Caution: if you set an incorrect
value at this point, the battery may be damaged irreparably, and
-
+ could even explode!
INC DEC
The fi nal charge voltage can be adjusted in 0.01V steps.
The max. charge voltage for LiPo is 4.2V, for LiIo 4.1V, for LiFe 3.6V.
To store the batteries, adjust the charge voltage about 0.4V lower
as the maximum charge voltage.
At charging/discharging the battery types will be displayed as
followed:
LiPo (LiMn) = LP
LiIo = LI
LiFe = LF
43