Getting Started - Waterpik Ultra Mode D'emploi

Hydropulseur sans fil
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16


GETTING STARTED

Important! Turn Dental Water
Filling the Reservoir
Jet off and charge for 1 hours
Lift flip top on reservoir and fill the reservoir with
before first use. Plug the cord into any
lukewarm water.
standard electrical outlet. The Waterpik
®
Ultra
Cordless Dental Water Jet will stay charged for
approximately 1 week depending on use. Make sure
you push the switch into the 'OFF' position. The unit
will not charge if the switch is in the ON position.
See "Care of your Waterpik
®
Ultra Cordless Dental
Water Jet" for guidance on how to look after your
battery.
Important!
Turn off.
OFF
Charge for 1 hours
before first use
(Stays charged for
approximately 1 week
depending on use.)
Inserting and Removing Tips
Insert tip into the center of
the knob at the top of the
Dental Water Jet handle.
The colored ring will be
flush with the end of the
knob if the tip is correctly
locked into place.
To remove the tip from
the handle, press the
jet tip eject button
and pull tip from
the handle.
Adjusting the Pressure Setting
Keep unit upright during use for best results.
Slide the pressure switch to low for first time
use and for gentle cleaning of sensitive gums.
Pressure
Setting

Direct the stream by turning the knob at the top
of the handle.

Publicité

Table des Matières
loading

Table des Matières