Neptun NSP 35 Mode D'emploi page 7

Anleitung NSP 35_SPK7:Anleitung SMP 410_1_S
Incidents – Causes – Remedies
Incidents
Pump does not start
No flow
Pump does not switch off
Insufficient flow
Pump switches of after short
operating period
16.05.2007
Causes
– No mains supply
– Floater does not switch
– Inlet sieve is clogged
– Pressure hose in bent
– Floater cannot sink down
– Inlet sieve is clogged
– Reduced pumping capacity by
dirty and abrasive water
– Thermal cutout stops pumps
due to dirty water
– Water too hot. Thermal-cutout
stops pump
15:46 Uhr Seite 7
GB
Remedies
– Check mains supply
– Bring floater in a higher
position
– Clean inlet sieve water jet
– Reset hose
– Place pump properly on shaft
ground
– Clean inlet sieve
– Clean pump and replace
worn-out parts
– Remove mains plug. Clean
pump and shaft
– Make sure that a water tem-
perature of max. 35°C is not
exceed
7