Neck Loop/Auxillary Port; Operation; To Place Or Receive A Call - Clarity C320 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

➤ Neck Loop/Auxillary Port

The C320 has a 3.5mm phono jack to use
with a neck loop. The volume to the neck
loop is controlled with the Clarity Power
Control. When the neck loop is plugged in,
the receiver in the handset is disabled.
➤ Operations
Once you have installed your Walker
C320 according to the instructions noted
previously, it will be ready to use.

➤ To Place or Receive a Call:

1. Adjust the Clarity
its lowest setting (zero).
2. Pick up the handset and listen for the
caller's voice or a dial tone.
3. When placing a call, dial as you
would any phone and wait for someone
to answer.
16
C320 FEATURES
®
Power Control
TM
to
4. Press the BOOST button.
5. Adjust the Clarity Power Control
upwards to a level where the other
party's voice is heard loud and clear,
and begin conversation.
6. When you complete the call, return
the handset.
7. After hanging up, the sound level will
reset according to the position of the reset
switch on the back of the telephone.
(See Boost Reset Switch instructions
on page 12.)
8. Pressing the BOOST Button during
subsequent conversations will return the
volume to your set sound level.
Note: If you made an error while dialing,
just depress the hookswitch, listen for a
dial tone, and dial again.
C320

Publicité

Table des Matières
loading

Table des Matières