Measuring The Clearances; Turning On The Power; Leveling - LG LTNC11121V Manuel Du Propriétaire

Measuring the Clearances

Too small of a distance
items may result in lowered freezing capability
and increased electricity consumption charges.
Allow at least 24 inches (61 cm) in front of
the refrigerator to open the doors, and at
least 2 inches (5.08 cm) between the back
of the refrigerator and the wall.
24" (61 cm)

Turning On The Power

1
Plug in the refrigerator.
CAUTION
Connect to a

 Have a certified electrician check the wall
outlet and wiring for proper grounding.
Do not damage or cut off the ground

terminal of
from adjacent
2" (5.08 cm)
rated power outlet.
the power plug.

Leveling

After installing, plug the refrigerator's power
cord into a 3-prong grounded outlet and push
the refrigerator into
Your refrigerator has two front leveling legs (one
on the right side and one on the left). Adjust the
legs to alter the tilt from front-to-front or side-to
-side. If the refrigerator seems unsteady, or you
want the doors to close more easily, adjust the
refrigerator's tilt using the instructions below:
1. Turn the leveling legs by inserting a flat blade
screwdriver in the holes located in the leveling
screws. Turn the leg clockwise (
that side of the refrigerator or counterclock-
wise ( )to lower it. It may take several turns
of the leveling leg to adjust the tilt of the
refrigerator.
NOTE
Having someone push backward against the
top of the refrigerator takes some weight off
the leveling legs. This makes it easier to adjust
the legs.
2.
Open both doors again and check to make
sure that they close easily. If the doors do not
close easily, tilt the refrigerator slightly more to
the rear by turning both leveling legs counter-
clockwise. It may take several more turns, and
you should turn both leveling legs the same
amount.
INSTALLATION 11
the final position.
) to raise
Leveling
Screw
Screwdriver