Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
12
INSTALLATION
Ambient Temperature
Install this appliance in an area where the
temperature is between 55°F (13°C) and 110°F
(43°C). If the temperature around the appliance
is too low or high, cooling ability may be
adversely affected.
Measuring the Clearances
Too small of a distance from adjacent items
may result in lowered freezing capability and
increased electricity consumption charges.
Allow at least 24 inches (61 cm) in front of
the refrigerator to open the doors, and at
least 2 inches (5 cm) between the back of the
refrigerator and the wall.
24" (61 cm)
Removing/Assembling the
Refrigerator Door Handles
Removing the Handles
1
Loosen the set screws
Allen wrench and remove the handle.
2
Loosen the mounting fasteners
connect to the refrigerator door and handle
using a
mounting fasteners.
2" (5 cm)
Assembling the Handles
1
Assemble the mounting fasteners
both ends of the handle using a
Allen wrench.
2
Place the handle on the door by fitting
the handle footprints over the mounting
fasteners and tightening the set screws
with a
NOTE
Removing the doors is always
recommended when it is necessary to
move the refrigerator through a narrow
opening. If it is necessary to remove the
handles, follow the directions below.
1
/
in. Allen wrench, remove the
4
3
/
in. Allen wrench.
32
3
with a
/
in.
32
that
at
1
/
in.
4
Publicité
Chapitres
Table des Matières
Dépannage
