Maintenance - Greencut GS2500 Manuel D'utilisation

MAINTENANCE

MAINTENANCE
Check for loose nuts and/
or bolts
Tighten all nuts and bolts
Air filter
Fuel filter (if equipped)
Spark plug
Cleaning the fuel tank
Fuel line
Chain
Adjusting the idle speed
Regular carburation
Cleaning the combustion
chamber
ATTENTION
• Always wear gloves when working around the blade assembly.
• Before performing any maintenance, repair or cleaning work on the unit, make sure that the
motor and cutting attachment are completely stopped. Disconnect the spark plug cable before
carrying out any maintenance work.
• Use only original spare parts for this machine.
• Operating the engine without a muffler or with a damaged muffler installed can increase engine
noise enough to cause hearing loss.
NOTE: This machine must never operate with a defective or missing spark arrestor or muffler. Make
sure the muffler is properly secured and in good condition. A damaged muffler is a fire hazard and
can cause hearing loss.
1. Carefully remove any accumulated dirt or debris from the muffler and fuel tank. The accumulation of dirt in these
can lead to engine overheating, fire or premature wear.
2. Check for loose or missing screws or components.
3. Make sure the cutting attachment is clean and securely fastened.
4. Check the entire machine for leaks of fuel or grease.
5. Make sure the nuts, bolts and screws (except the carburetor adjusting screws) are tightened.
EVERY MONTH
EACH USE
OR 12H. USE
Check
Check
Check
Check
EVERY 3 EVERY 6
MONTHS MONTHS OR
OR 30H. USE 60H. USE
Complete Replace
Clean / Replace if necessary
Check Replace
Check Replace
Complete Replace
Replace if necessary
Replace if necessary
Check
Check Replace
73
EVERY 12
MONTHS OR
EN
100H. USE
Adjust