Product Use; Maintenance - Greencut PODADORA PP400L Manuel D'utilisation

46
MOWER LUBRICATION
• Good lubrication can reduce the frictional force between the saw and the bar and thus extend the service life of
your machine.
• Use a high quality professional lubricating oil.
• Do not use old or unknown oil to avoid causing a malfunction.
• In case of emergency, allow dynamo to be used to replace.
• Use Sae30 in summer.
• Use Sae10 in winter or when using the pruner to prune trees with a lot of resin.

PRODUCT USE

START UP
Before starting operation, the battery must be installed in the machine.
To start the machine:
1. Press the trigger release button with your thumb.
2. Pull the throttle trigger.
Once the throttle trigger is pulled, the trigger release is fixed and you can release it.

MAINTENANCE

Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly.
ATTENTION: Use only original parts, accessories and manufacturer's couplings. Failure to do so may
result in injury, tool malfunction and may void the warranty.
ATTENTION: Repairs require extreme care and knowledge and should only be carried out by a
qualified technician. For repairs, we suggest that you return the product to the nearest authorized
service center for repair. When carrying out repairs, only use identical spare parts.
ATTENTION: Make sure the engine is completely shut down before performing any maintenance
or repair. This will eliminate any potential risk.
• You can make adjustments and repairs described here. For other repairs, please contact the Official Technical Service.
• Before any maintenance or adjustment, deactivate the machine by removing the battery.
• After extending the new cutting line or cleaning, checking the blade, always return the product to its normal
operating position before starting any operation.
• After each use, clean the product with a soft, dry cloth.
• Check all nuts, bolts and screws at frequent intervals to ensure that the product is in good working condition. Any
damaged parts must be repaired or replaced by an authorized service center.