Product Use; Battery Installation - Greencut GS200L Manuel D'utilisation

PRODUCT USE

PUT CHAIN LUBE OIL
ATTENTION: Never work without chain lubricant. If the saw chain works without lubricant, the bar
and the saw chain may be damaged. It is therefore essential to check the oil level in the oil level
indicator frequently and also every time before you start using the saw. Use special chainsaw oil.
CHECKING THE LUBRICATION
1. Start the device.
2. Keep the saw chain running at about 15 cm per surface for a short period of time (15 s). If there is enough
lubrication, the oil coming out of the saw chain will form a slight trace.
OIL FILLING
1. Place the device in a safe position with the oil tank cover upwards.
2. Before opening, clean the oil tank cover if necessary.
3. Remove the oil tank cap by turning it counterclockwise.
4. Carefully fill the oil tank with chainsaw oil. Do not spill it. If you spill any drops,
be sure to clean them up.
5. This device contains an automatic oil pump that lubricates the chain. Check
the remaining oil level through the oil level window (9).
6. Place the oil tank cover by turning it clockwise.

BATTERY INSTALLATION

NOTE: If the battery is fully charged, the charger will automatically switch to the maintenance
charging function. In this way, the battery can remain in the charger safely and indefinitely.
ATTENTION: The battery must be charged before the first start.
1. Press the lock button and remove the battery from the device.
2. Insert the battery into the charger.
3. Plug the charger into the power supply unit. The charge status is shown
by the indicators on the charger.
4. Insert the battery pack into the device and make sure that it clicks into
place correctly.
LOAD INDICATORS
• 4 leds on: The battery is full.
• 1,2 or 3 leds on: The battery has enough energy.
• 1 led on: The battery is empty. Recharge the battery.
• 4 leds blinking: The battery is too hot or too cold. Do not use or charge the battery, wait until the battery
temperature is between 4ºC and 40ºC.
63
EN
17