Greencut GS2500 Manuel D'utilisation page 68

68
BOX CONTENTS
1
1. Chainsaw
2. Chain
3. Sword
4. Protector of the sword
5. Harness
6. Allen key
7. Screwdriver for carburetor adjustment
8. File
• Carefully remove the product and accessories from the box. Make sure that all the items listed above are present.
• Inspect the product to ensure that it has not been broken or damaged in transit.
• Do not discard the packaging material until you have carefully inspected and satisfactorily used the product.
ATTENTION: If any part is missing or damaged, contact the Authorised Service Centre. Do not
use this product without having replaced the missing or damaged part. Using this product with
damaged or missing parts can cause serious injury to the operator.
ASSEMBLY
ATTENTION: The chainsaw may come with plastic spacers on or around the sword bolts, the spacer
is for shipping purposes only and must be removed before mounting the sword. After removing the
brake cover, remove the plastic spacers you find and then mount the sword as described. Failure to
remove the spacers before mounting and using the chainsaw may result in injury, damage to the
unit and void the warranty.
Open the box and install the guide bar and saw into the power unit as follows:
1. Pull the chain brake handle toward the back of the saw (or pull toward the back of the saw if the chain
brake was installed on the saw).
2. Loosen the nuts and remove the unit from the chain brake cover assembly.
3. Install the claw (toothed part) on the unit (some models only).
4. Mount the chain on the sprocket and, while adjusting the chain around the guide bar, mount the bar in its
housing. The cutting chains are directional, so make sure you have them installed correctly.
4
12
2
3
9. Spark plug wrench
10. Gear lubrication pump (replacement)
11. Mixing pot
12. Hearing protector
13. Glasses
14. Gloves
15. User's manual
8
5
7
6
13
15
ES FR IT EN i
11
9
10
14