Operation; Using The Temperature Mode (Default Mode Whenever The Machine Is Switched On); Using The Time Mode; Work Piece Removal - BEGA BETEX Standard 22 ELDi SUPER Mode D'emploi

7. Operation

There are two modes of heating:
Temperature Mode:

Used for controlled heating up to the
desired temperature.

Used when you wish to keep the work
piece at the desired temperature for up to
15 minutes.

7.1 Using the Temperature Mode (Default mode whenever the machine is switched on)


Set up the work piece and probe according to the instructions in sections 5 & 6.

Switch the machine on. The display will show 100c (or 100F). Enter the desired temperature to
which the work piece will be heated up to using the '▲' or '▼' key (by pressing the temperature
mode key ( ) you can choose between steps of 1º or 10º - this is the same whether working in C
or F).

Press the 'START' key. Heating starts and a soft buzzing sound will be heard.

The current temperature of the work piece appears on the display. When the desired temperature
has been reached, the display starts to blink and a loud beeping is emitted. Unless you press the
'STOP' key, the heat-retention function will keep the bearing at that temperature for 5 minutes.
The machine resumes heating after a temperature drop of 3º (C or F). When the set temperature
is reached once more the induction heater emits a loud beep. Press the 'STOP' key to switch off
the machine.

The heating process or the heat-retention function can be interrupted at any time by pressing the
'STOP' key.

7.2 Using the Time Mode


Set up the work piece and temperature probe according to the instructions in sections 5 & 6 (the
temperature probe is only necessary if you want to check the temperature).

Switch the machine on and press the time mode key '  '. Press the '▲' or '▼' key to set the
desired time (by pressing the time mode key '  ' you can choose between steps of one minute or
one second).

Press the 'START' key. Heating starts and a soft buzzing sound will be heard.

If the temperature key ' 'is pressed while heating, the current temperature is displayed for 3
seconds. After that the countdown is resumed.

During the heating process the set time runs to 00:00. When 00:00 is reached the induction heater
switches off. The work piece is then automatically demagnetised and a loud continuous beeping is
emitted. Press the 'STOP' key to switch off the machine.

7.3 Work piece removal


After pressing the 'STOP' key, place the probe on the side of the vertical pole. Pressing the
'STOP' key always causes the work piece to be automatically demagnetised.

Using heat-resistant gloves, grip the yoke with the bearing on it and place it on a clean, heat-
resistant surface. Mount the bearing immediately to prevent cooling. If using a model with a swing
arm, swivel the yoke with the bearing on it into the fixed, open position (at 45º). Slide the bearing
from the yoke. Mount the bearing immediately to avoid heat loss.
Time Mode:

Suitable for batch production. If the time
taken to heat the work piece to the desired
temperature is known.

Emergency use if the temperature probe is
lost or defective. The temperature of the
work piece should be checked using an
external thermometer.
13