Maximum Weights For Swing-Arm Models - BEGA BETEX Standard 22 ELDi SUPER Mode D'emploi


Always make sure that the workpiece has no direct contact with the plastic housing of the heater.

When heating cycle is ready, follow the above instructions in opposite order to take of the heated
work piece. Wear protective clothing like heat resistant gloves because the workpiece is hot now.
(Supplied gloves are suitable for 150°C (302°F).

Always treat yokes carefully falling, jolting, etc, can damage them. Always put the yoie away
immediately after use.

5.2. Maximum weights for swing-arm models

Table showing the maximum permitted weights on the horizontal supports & swiveling yokes:
Heater On
Series Supports
22 ESDi 65 kg
24 RSDi 150 kg
38 ESD 150 kg
38 ZFD 300 kg
40 RSD 350 kg
40 RMD 600 kg

To avoid the heater from tipping and damage to the yokes and the hinge construction, the
maximum weight for each size yoke is restricted.

Parts with a higher weight can rest on the horizontal supports (if fitted), or be supported by a
non-metallic rope from a crane, avoiding any weight on the yoke.
Diagram showing how the work piece can be supported:
22 ESDi, 24 RSDi & 38 ESD
20 mm 30 mm 40 mm
5 kg 10 kg 15 kg
10 kg 15 kg 25 kg
10 kg 15 kg 25 kg
10 kg 20 kg 30 kg
10 kg 20 kg 30 kg
n/a n/a 30 kg
11
Swing Arm Yoke Size
50 mm 60 mm
20 kg 25 kg
40 kg 45 kg
40 kg n/a
n/a 60 kg
n/a 60 kg
n/a 60 kg
38 ZFD, 40 RSD & 40 RMD
70 mm 80 mm
n/a n/a
n/a n/a
50 kg n/a
n/a 80 kg
n/a 80 kg
n/a 80 kg